Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
I have recently just brought my old printer back to life (RAPMAN 3.1) with an e3d v5 hot end and RAMPS 1.4 controller.
When it comes to moving on to the next layer the bed moves down a good 4-5cm. Ive looked in all the settings and the gcode from cura, it all looks normal.
I have also had a look in the marlin firmware config but cant see anything that would give me this result.
Manual control in
by
Stabilize
-
Firmware - mainstream and related support
I recently purchased a Rapman 3.1 with a faulty hot end. It gets hot but shuts down due to thermistor error.
I plan to replace the hotend with an e3d v6 soon but at the moment I dont have any 200k thermistors. Can I wire 2 100k in series? I understand that the ramp will be different but possibly usable until I can create a better solution.
Thanks
by
Stabilize
-
Controllers