Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hello every-one,
Just to keep you informed, I replaced the inductive sensor with a conductive sensor, and I am now using a glass sheet over my aluminium bed (to ensure the bed is perfectly flat), and sadly, it didn't resolve the issue.
The "shift" is still the same, so I guess the issue comes from either my installation, or from the firmware.
As the firmware is based on a Marlin 1.1.0 RC6, so
by
RVE
-
Printing
The aluminium bed is brand new, so I think that it is OK, plus the issue was already present with my previous bed, so I guess it doesn't come from there.
The probe doesn't shift, and I am sensing the same surface during all the auto level process (the aluminium bed).
The offset I had to set in my firmware was -0.65mm.
I just thought about one thing though, the metal structure supporting the al
by
RVE
-
Printing
Hello,
I would like some advice on a recurring issue I am facing with my Prusa i3 (with inductive sensor and auto bed-levelling).
So, my issue is that when I start a print with autolevel, autolevel mesure is performed without issue, but when printing, the level is not perfectly corrected by the autolevel function :
I can see some correction being performed (both Z axis lead-screws are slightly
by
RVE
-
Printing
Hello everyone, I am back,
I finally managed to breath some life into my MKS base, or at least to flash it a corect bootloader !!!
If anyone is interessted, I have been following roughly the same steps agehall did.
As it was a first time for me, this tutorial really help me understand what I had to do : best way flash bootloader arduino
The tutorial is focused on arduino to arduino programmi
by
RVE
-
Firmware - mainstream and related support
Hello,
It seems that I am facing the same issue than agehall was facing, I was uploading custom firmwares to my 3D printer (based on a MKS bas e1.4) using Cura and one upload failed.
Since then, the screen on my 3D printer will only show blank lines, and I cannot upload any new firmware (arduinoIDE will return the follwing error message every time :
avrdude: stk500v2_ReceiveMessage(): timeout
by
RVE
-
Firmware - mainstream and related support