Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Hi.
i got it working, it was way to much air from the 2 fans, i think that even the hot end fan helps in small
pieces, i print a calibration cube 25 x 25 x 10mm and as soon as the fans kick in in the 2nd layer
i stop the fans and went great.
i am thinking on slicing small parts at a20% fan in the 2nd layer on.
thanks
by
betoys
-
Firmware - mainstream and related support
Hi.
i got it working, it was way to much air from the 2 fans, i think that even the hot end fan helps in small
pieces, i print a calibration cube 25 x 25 x 10mm and as soon as the fans kick in in the 2nd layer
i stop the fans and went great.
i am thinking on slicing small parts at a20% fan in the 2nd layer on.
thanks
by
betoys
-
Firmware - Marlin
Hi.
thanks for your help.
i change to PIDTEMPBED and run the test to get the values to store in the firmware.
but no luck.
i also change the BED_MAXTEMP to 110
i will check the wiering,
question. if the wiering is bad what puzzles meis that the print stops almost in the same high.
another question i have the hot end fan (E3dv6) and also 2 more fans for cooling the filament, can it be to mu
by
betoys
-
Firmware - Marlin
HI.
thanks for your help.
i will check that the thermistor is in contact with the bed.
i already change to PID and aslo run the PID to get the values and store them in the firmware.
how do i know if tthe thermistor is the right one i select on the firmware?
I connect the second power supply 12v out to the mosfet DC in, the hot bed wires to the mosfet and the control to the ramps hot bed.
i
by
betoys
-
Firmware - mainstream and related support
Hi All.
i have this problem with my delta printer i just finish
hope someone can help me.
i am using marlin 1.1.4
when i slice a model with no heated bed it prints ok with PLA 210 hot end ( with the warping usual problems )
but when i slice the same model with the heated bed ( 60 degrees ).
it stops and gives me a thermalrunaway message.
and the power supply ( 12v DC 30A 360w ) was geting kind
by
betoys
-
Firmware - Marlin
Hi All.
i have this problem with my delta printer i just finish
hope someone can help me.
i am using marlin 1.1.4
when i slice a model with no heated bed it prints ok with PLA 210 hot end ( with the warping usual problems )
but when i slice the same model with the heated bed ( 60 degrees ).
it stops and gives me a thermalrunaway message.
and the power supply ( 12v DC 30A 360w ) was geting kind
by
betoys
-
Firmware - mainstream and related support