Thanks for the replies I will change the extruder feed rate when I get home, and I will post back with the results!by GreysonH - General Mendel Topics
With the help of this forum I was able to put my RepRap Mendel Prusa all together and start printing! I printed my first calibration cube, but for some reason my temps spiked up to 230 degrees (I'm printing in PLA) so the print was a off, I started the second cube shortly afterwords and ran it again, the temperatures spiked up again but I adjusted it back down in pronterface while it was printingby GreysonH - General Mendel Topics
Thanks for the reply and info! I will make the changes to my X and Y endstop locations when I get home. But my Z endstop is at the bottom near the heating bed. When I clicked the home button for the Z axis the extruder traveled down towards the heating bed and hit the endstop but the extruder still didn't stop moving down. Is there a problem with my Z endstop?by GreysonH - General Mendel Topics
Hey so I have reciently completed the building process of my RepRap Prusa i2 but I have run into a couple different problems when trying to move around / calibrate my motors. First of all I was running in to an issue with my Z axis motor going backwards but I fixed that by just flipping around the connector. Im wondering if my Y motors is moving in the right direction, If I Click + on Pronterfaceby GreysonH - General Mendel Topics