Show all posts by user
Page 4 of 4
Pages: 1234
Results 91 — 101 of 101
First off thank you NopHead for the very well put together kit and awesome support. It took around 20-24 hours from start to first print in about 2 weeks.
My comments on the Manual/Build are below
Build/Mannual
General Build tips - add "Keep the box for the heat shield as a note"
Tools Required - add "Needle nose pliers"
Consumables - add "Sticky Tape"
Below Tool Required - add a Optional equip
by
RyanMark
-
Mendel90
Thanks, I did try ports 3 and 4 previously. I just tried port 5 and it seemed to work. Cheers,
by
RyanMark
-
Mendel90
I am not able to connect my computer to printer. When I try to connect Pronterface give the following error.
Thanks.
Traceback (most recent call last):
File "pronterface.py", line 1566, in connect
File "printcore.pyc", line 76, in connect
File "serial\serialwin32.pyc", line 30, in __init__
File "serial\serialutil.pyc", line 260, in __init__
File "serial\serialwin32.pyc", line 56, in op
by
RyanMark
-
Mendel90
I purchased the following PSU (Manual), and I wanted to double check I am wiring correctly.
The Alpine PSU (in the Mendel90 manual) has 36 wires but the PSU above has a few more. I think I am supposed to use the following wires from my PSU:
(24 wires) 4.1 Motherboard 20+4Pin Connector (P1)
(4 wires) 4.2 CPU 4+4Pin Connector (P2, P3)
(4 wires) 4.5 Peripheral 4-Pin Connector
(4 wires) 4.6 Floppy
by
RyanMark
-
Mendel90
Link to the wiki section is below:
Wiki Printed Parts
by
RyanMark
-
Mendel90
Correct me if I am wrong but couldn't you print at a 0.2mm layer height and come out with the correct dimensions?
by
RyanMark
-
Mendel90
Lithium Grease, as per page 67 of the design manual. You can buy it from most hobby shops or ebay.
by
RyanMark
-
Mendel90
I am in the middle of constructing my Mendel90 and some of my first prints will be spare parts for the printer.
What parts are prone to break? (ie what should I print first?) And what fill, layer height etc. should be used on the printed parts?
by
RyanMark
-
Mendel90
I enjoy browsing the interenet on occasion at work and was wondering if anyone could recommend any 3D printing blogs that get updated on a regular basis?
Also feel free to self promote if you have your own blog.
Cheers,
by
RyanMark
-
General
So, I went ahead and bought the one from Tigerdirect as Nophead said it would work. In case anyone else was wondering which PSU to buy.
Thanks.
by
RyanMark
-
Mendel90
I am on the waiting list to buy a Mendel90 from Nophead but it doesn't come with a PSU. I am thinking of purchasing this one Potential PSU.
Does anyone have any recommendations on a brand and place to buy online? (I live in Canada)
Thanks in advance.
by
RyanMark
-
Mendel90
Page 4 of 4
Pages: 1234