I installed the u8glib and everything compiled fine and uploaded. I think I may have a bad part to be honest, but I'm not sure. I'll try it again later, maybe I was using an old version or something. Any idea of how many amps I can or should put through it?by prusanoob - Controllers
I have an unbranded 240v 20Amp 12v powersupply and a Megatronics v2.0 kit: Main problem: My heatbed mosfet is getting ridiculously hot when the second 12v line is hooked up whether the heatbed is on or off. I put a small heatsink on it, but its still far too hot, burn your skin hot. The heatbed works but I wouldn't like to have it on for more than a few seconds. Does anyone know why that mightby prusanoob - Controllers
I had to use an older version of arduino IDE 0022, then I was able to upload repetier firmware and it worked. Slic3r won't compile now, but I've gotten further anyway. It looks like I do have an intact bootloader so I don't need to buy a programmer.by prusanoob - Sanguino(lolu)
I've just put together my prusa i3 with an sanguino 1.3a and when I hook it all up, my stepper motors go back and fourth about half a turn and all I can see in pronterface is numbers scrolling up, which I suspect are the thermistor outputs. It looks my stepper motors are disabled. Is that easily fixed? I don't seem to be able to send anything to it like a print file or a sketch in arduino IDE,by prusanoob - Sanguino(lolu)