Oh hang on I think the wiring is different! OOPS!by Kozmik_Kat - Stepper Motors, Servo Motors, DC Motors
OK so I built the Mendel using 17HS19-1684S stepper motors for all 3 axis and extruder. I then purchased the tricolour upgrade kit which came with different smaller motors (JK42HS34-1334A). I decided to buy an extra motor to replace the original extruder motor so all 3 would be the same. Now when I switch on the Mendel the extruder motor clicks away merrily to itself (which it shouldn't do) so Iby Kozmik_Kat - Stepper Motors, Servo Motors, DC Motors
OK sorted it. Baud rate should of been 19200by Kozmik_Kat - Reprappers
Hi Everyone Very new here. OK so ive built a Prusa Mendel and opted for the Gen6 electronics because its "all in one". No heatbed support so regretted buying Gen6 already! But thats not my problem..... So Ive wired it all up, installed the FTDI drivers on my Win7 PC. Switched on the Reprap - 2 funky lights light up on the Gen6. PC says its found COM3. Yay so far so good! Tried to find Repsnapby Kozmik_Kat - Reprappers