That indeed was the issue. The Z Stepper was incorrectly wired. A little strange that the Z stepper was plug and play on both the RAMPS 1.4 board I was using and the stock CR10 board. Thank you both for the suggestions!by sortinousn - Stepper Motors, Servo Motors, DC Motors
Hi, The CR10 has only 1 Z stepper. I just upgraded the firmware to 2.02. When I try to home Z i get this notification... × Warning: motor phase A may be disconnected reported by driver(s) 2 Warning: motor phase B may be disconnected reported by driver(s) 2by sortinousn - Stepper Motors, Servo Motors, DC Motors
I'm in the process of upgrading my Creality CR10 with Duet2Wifi. The Z axis stepper on the creality is slightly smaller 34mm. I have been unable to get the the Z motor to respond at all. I've tried homing and sending G1 Z10 F1200 via pronterface. There's no vibrating or movement at all and the stepper turns freely as if it wasn't powered. When I replaced the stepper with a normal 40mm the steppby sortinousn - Stepper Motors, Servo Motors, DC Motors