Hi dc42, I've worked out (rounding down) to 250mm does that sound about right? Thank you for the help! Ckby mrboost - Delta Machines
Morning everyone! I've started building my second printer, a rostock mini! and I would like to make the print bed slightly larger then 6X6 inches. According to the rostock mini reprap page the design is good up to 12X12 print bed. I would like to make mine 8X8 as I have a ton of 8x8 heat beds and glass laying around. I know I need to make the frame (top and bottom plates larger) and the rods neeby mrboost - Delta Machines
Great thank you so much! one last over look what about going from the PSU to the RAMPS board would the 14/16AWG be ok? Thank you again! Ckby mrboost - Controllers
Hi everyone! I'm nearing the end of my month long build and I need a little help with wire selection. Mainly with what wires to use... Can I use 22 gauge wire for the steppers, therm resister and some smaller PC wire for all the smaller electronics? I have a few spools of wire from radio shack I use for other projects it reads ( AWM 1007 22AWG 80C 300V 1A VW-1 ) Thank you for the help! CKby mrboost - Controllers
Ohhh ok, I'm using the wade extruder as that is what came with my printed parts. I think i'm going to go with a a J-head V clone. Thank you for the help! Ckby mrboost - Controllers
Great thank you, I'm not sure what extruder I thought the hotend was the extruder? Thank you, Ckby mrboost - Controllers
Hi, I'm working on my Prusa i3 rework and i'm at the point where all I need is a hotend. The parts list says I need a Magma hotend but I can't seem to find any for sale... Is there an alternative or something better that I can use? Thank you, Ckby mrboost - Controllers
Thank you, I just ordered a set!by mrboost - Stepper Motors, Servo Motors, DC Motors
Does the height of the motor matter at all? I know two of them are going to act as legs or supports. I don't want to order the wrong thing and have it off kilter lol.by mrboost - Controllers
Thank you very much! I don't know if I would be pushing it but would you be able to point me in the direction of a good RAMPS board and the correct set of motors as well? Thank you again, Ckby mrboost - Controllers
Great thank you for the help I'm guessing it's this little guy? Thank you again, Ckby mrboost - Controllers
Would this be a good motor to use? (for prusa i3 rework) Thank you, Ckby mrboost - Stepper Motors, Servo Motors, DC Motors
Hello, I was hoping I could get some opinions on what the best stepsticks and ramp 1.4 boards are. I really want to go with quality for my Prusa i3 Rework. I'm looking at elecfreaks A4988 currently. Thank you, Ckby mrboost - Controllers
Morning everyone, I've tryed to search the fourm and other sites but I'm still having issues finding information on the last few parts I need to start my build. The first issue is what NAME 17 stepper I should use for the build? My under standing is there are many different NAME 17 motor specs and heights of motors. I'm really unsure what I need, does the height of the motor matter? since two wiby mrboost - Stepper Motors, Servo Motors, DC Motors