Traumflug, Just to close off this conversation, I downloaded Pronterface from the link to Kliment you so kindly provided and success. Connected immediately and all works (even the temperature) Should I replace the choke with a 10uh item? Thanks again for all the effort you've put into Gen7. It's very much appreciated.by Rotormac - Next Wave Electronics Working Group
Traumflug, Picture me sitting here with a large red face! I read the Gen7 1.3 build instructions RIGHT TO THE BOTTOM this time and found again the instructions for the standby thermistor mod. Tracks cut and links added, temperature is now reported on standby. Forums are great but instructions are better, when read fully ;-')by Rotormac - Next Wave Electronics Working Group
Traumflug, Thanks for the very timely response. Obviously I had already checked for shorts in the thermistor area and found none. I checked again this AM just to be sure age was not catching up on me (too fast). I did mention Gen7 1.3 electronics. The M105 output I posted last evening was obviously when the power supply was not active. When the supply is activated, the temps are good. I reby Rotormac - Next Wave Electronics Working Group
Folks, Has anyone a recommendation for suppliers of 2 mm ID PTFE tube in Europe? I can find 25 Metre lengths but all I want is a single metre! Best regards,by Rotormac - Reprappers
Hi all, I've been building my Mendel for some time now, using Gen7 1.3 electronics purchased, assembled and had basic tests over a year ago. I've just finished the wiring and am at the testing stage. I'm using Arduino 1.0.5, loaded Traumflugs mini test and happily the AT power supply switched on and the lights blinked. I went ahead and loaded up Teacup firmware, sent an M114 and gotby Rotormac - Next Wave Electronics Working Group