I runned RRF with my config in SKR2. (I have 3 external TB6600 drivers connected via STEP/DIR mode and 3 classical EndStops) After first boot, from two red LEDs, I have left flashing and right on. I connected SKR to Pronterface and I only have some random movements in one of the motors. There is no response to any request. In parallel, I connect a TTF, but currently it is useless. I only neeby xXJRUSHMANXx - General
Hello everybody, I'm making polar printer like this one: YouTube Firstly I tried Marlin, actually I'm trying RRF, but there is no way I can control my machine. I can't even get a correct connection. Can somebody help me with RRF? I can give my RRF config if somebody needs it. Its possible use ArduinoUno with CNCshield?by xXJRUSHMANXx - General
dekutree64, It is Marlin or RRF?? Do you khnow manipulate polar printer with SKR2 and RRF? I'm trying it but I can't give it.by xXJRUSHMANXx - Developers
Do you have something? I'm trying same cinematics with SKR2 and RRF but there is no way to control it...by xXJRUSHMANXx - General
Hello everybody, I'm doing some type of polar printer and there is no way I can control it. It's about SKR.v2 with 3*nema23 ( Tb6600 drivers) where one of then is an angular moviment. I'm speaking about a custom cinematic. Actually I'm searching for somebody who can help me with it, I will reward for it. This project is so important for me, I hope someone can help me. Thanksby xXJRUSHMANXx - "Hello, I'm a designer." "I'm an engineer."
I appreciate the help!!! I did not expect this participation. It seems that I will be updating my project as time goes by. About the clock, actually I needn't so much mechanical speed, I hope it's irrelevant in that way. Obviously at the future I will update all my drivers. Hope have no problems with communication. About Marlin, my idea is to print thinks, so I don't khnow if its so difficultby xXJRUSHMANXx - General
Hello, I'm trying to make my own 3D printer with 3 nema 23 ( with external TB6560) and an simple nema from ender ( with TMC). I'm using SKR V2 and I will write own Marlin. Actually I have some questions: 1) Can I connect my TB6560 to CSL pin-out of SKR? There is only 4 of 6 pins ( Gnd, Dir, Pul, EN) What jumper configuration I should to have? There is nobody using external drivers in SKR V2....by xXJRUSHMANXx - General