HI all, Last night I spent some time getting ReplicatorG to work with my Huxley. Here is where you can get it: http://replicat.org/ It will not work unless you use the correct machine setting. It comes with quite a few already setup, but I could not get it to work with any of them, so I had to hack an xml file to work with the Huxley. I have attached the file that I have used. To makby Thunor - Huxley
Painters tape did not seem to work that well for me. I was able to get better adhesion to the build platform by using clear packing tape or black electrical tape. Currently I have issues with objects having points that extend to infinity. These errors show up as long lines stretching away into the distance. I get this problem on a lot of parts, even the stl files that come straight from the wby Thunor - Huxley
Just use a regular Cat5 Ethernet cable. I had the right cable in the kit, but one of the wires did not make it into the connector. You could see it pushed back through the clear connector plastic. I hooked up a much longer Ethernet cable and the heater works fine now.by Thunor - Huxley
Has anyone been able to print with the Huxley? I have only been able to print out the 1cm test cube. Everything else that I try to print works fine for the first layer or two, then tries to go way off the build platform. I am using the TechZone Huxley with Monotronics. Repsnapper is the only software that will connect with the Huxley, I have not been able to get either RepRap Host or Replicatby Thunor - Huxley
Hi, I have a TechZone Huxley and am trying to figure out how to set the defaults for the RepSnapper software. I don't see anywhere in the software that sets the default extruder speed and temperature. Is there such a setting?by Thunor - General Mendel Topics