Thought this would be useful for anyone else who was having the same problems. Temperature was a little a hot and I found this technique to be the most useful way of determining the correct temperature: "Start by doing a simple extruder test to determine what the range of temperatures are that you can extrude at. Reduce the temperature in 5 degree increments until the extruder starts skipping whby cokezero91 - Printing
Ambiguousphoton did you get this to work?by cokezero91 - RAMPS Electronics
Nozzle Size: 0.34 mm Layer Height: 0.25 mm Width: 0.4mm (the one under the layer height in sfact) What width setting would you recommend changing to?by cokezero91 - Printing
Hi All, I have just bulit a prusa mendel, and I am using HW: Ramps 1.4, SW: Pronterface => SFACT. I seem to be having problems with infill, as can be seen in the attached picture. (best described as mounds which don't connect together well. E-steps has been calibrated, and infill is set to 0.35 in SFACT (default setting). Any help would be greatly appreciated. Thanks.by cokezero91 - Printing