Quotesinned What are your steps/mm for the extruder in the configuration file? Are you taking into consideration the changes in native usteps? Double checked your electrical connections? What about wiring? Are you pairs rights? If it wall all working fine then it wouldn't apply but if you have a break in a wire somewhere, it could mimic bad wiring. I checked the wiring and it was fine. But yoby Nicoolai - Firmware - Marlin
Hi guys, I've replaced my printers board with a RAMP 1.4 and Marlin 1.1.8. I've put the TMC2130 drivers on, on all axis (including extruder). Everything seem to be working, except my extruder. When I run it, in both directions, it simply stutters for the duration of the extrude but doesn't move backwards or forwards. Just back and forth, over and over. This happens without filament in it, so it'by Nicoolai - Firmware - Marlin
Ok, so I made new wires for Y and E0. It fixed E0. Y is still acting up. I will try to switch some drivers around, see if it follows.by Nicoolai - RAMPS Electronics
Ok, I set debug and used M122 S1. It returned the following: READ: X:0 |0b1000| Y:255 |0b1111| E Z:1 |0b1000| E:255 |0b1111| E READ: X:0 |0b1000| Y:255 |0b1111| E Z:1 |0b1000| E:255 |0b1111| E SENT: M105 READ: ok T:22.00 /0.00 B:22.00 /0.00 @:0 B@:0 READ: X:0 |0b1000| Y:255 |0b1111| E Z:1 |0b1000| E:255 |0b1111| E READ: X:0 |0b1000| Y:255 |0b1111| E Z:1 |0b1000| E:255 |0b1111| E Overby Nicoolai - RAMPS Electronics
Hi guys, I'm having somewhat of an issue here. I just recently replaced my printer board with a ramps 1.4 board so I could utilize the TMC2130 drivers. So I also got 4 of those, and have wired them according to this guide: I've got Marlin 1.1.8 on it, and did all the changes I believe necessary, to utilize the TMC2130's. Unfortunately, when I power the printer on, I get the following message:by Nicoolai - RAMPS Electronics