Hello, recently bought a ramp shell 1.4 and am using the Arduino Mega 1280 with the 10.10 pronterface and ubuntu, but I had problems with printing, because each time the print in the middle, someone could help me with this? thank you ps. worked hard to put part of buffer'm not getting satisfactory results using firmware sprinterby danielramos - RAMPS Electronics
Hello, recently bought a ramp shell 1.4 and am using the Arduino Mega 1280 with the 10.10 pronterface and ubuntu, but I had problems with printing, because each time the print in the middle, someone could help me with this? thank you ps. worked hard to put part of buffer'm not getting satisfactory results using firmware sprinterby danielramos - RAMPS Electronics
friend know that this is not the right place for you this more I ask you please send me the firmware that you used on ramps'm riding in my project aki Brazil but I do not understand that part of firmware atravez of replicatorg. Thank you and I'm waiting. can send me e-mail danielramoseraquel@gmby danielramos - Controllers
ola estou tambem no brasil tentando construir uma reprap mas não tenho muito conhecimento em eletronica por esse motivo não sei qual a a necessidade dos componentes eels tem que ser muito forte (watts) ou podem ser mais fracos como é que eu faço pois na lista que baixei no site não tem as especificações necessárias... desde ja agradeço pela ajuda... abraços.by danielramos - Brazil, São Paulo RUG
Hello everyone, I was looking at the design of electronic generation 3 and downloaded the component list but did not find the capacity and each component with the amount of watts used by exeta resistors used in a motherboard that is 5 W but this is not the same nessesario be used ... how are you doing about it?by danielramos - Controllers