Now I tried to put some unrealistic values for the x toolhead offsets, but even then the printer shows the same "little bit displaced" printing. I even tried to change the toolhead offset values of the xml driver file in the ReplicatorG folder... Nothing changes... Its seems, that the printer ignores all toolhead offset changes... but why?von VoodooDE - Printing
Two more pics, one with X-Toolhead-Offset at 33.5mm, and one at 34,5mm... I can see no difference... :-(von VoodooDE - Printing
Here is a picture...von VoodooDE - Printing
Hello together, I got the CTC Replicator Dual Makerbot Clone. Firmware is the Sailfish 7.7 Firmware and I use ReplicatorG Sailfish 40r33 or for Dual-print with PVA as support-material I use the Makerbot Desktop. Now the both nozzles are a little bit wrong calibrated, so that one of the both colours are printed a little bit displaced (1 to 1,5mm). Normally thats not a big problem. You print thvon VoodooDE - Printing
Danke für die schnelle Hilfe. zu1 Wie kann ich denn die Wäremausdehnung in der Düse verhindern? 210 Grad sollte doch nicht zu viel für die Düse sein... zu2 Was kann man denn da falsch machen? Ich habe das Filament ausgepackt, auf die Halterung gesteckt und in den Extruder geladen.von VoodooDE - Allgemeines
Hallo zusammen, ich habe mir einen neuen 3D-Drucker zugelegt, den Makerbot-DualExtruder-Clon von CTC. Nach ewigem Rumgestelle an Temperatur, Kalibierung der Nozzle-Höhe usw. sind mir einige gute Ausdrucke gelungen mit PLA (ABS bekomme ich trotz Kapton-Tape und Heizbett nicht zum Haften). Vier Fragen habe ich allerdings noch: 1. Ich habe das Gefühl, dass der Abstand vom Bett zur Nozzle währendvon VoodooDE - Allgemeines