Hey team, out of the blue my MKS Gen L based printer shows a temp of about 100 deg (HE: 98, Bed: 96). They both started doing it on the same day. So my question is how likely is to that both termistors blow up at the same time? And how would you start debugging that issue? Thanks for help!von flobo79 - General
Moin allerseits. Das Problem ist, dass der Feeder vom 2. Extruder nicht anläuft. Ich starte den Loading-Vorgang, er heizt auf, erreicht seine Temperatur, auf dem Display erscheint " .. feeding now blabla ..., press to stop" aber der Feeder-Motor geht nicht an und zieht daher das filament nicht ein. Hat jemand einen heissen Tip für mich wo ich mal schauen soll? Drucker: ich habe einen Berlin i3von flobo79 - Allgemeines
phew .. thanks for the todo list, I'll try to work through it by tonight. > could you attach the configuration.h file? I need to find out how to geht the config.h file from the printer, with Max OSX. > Did you try the motor on extruder 1? Not yet, good point! > Did you try swapping the stepstick? Whats that? > Is the motor current calibrated? Not sure, I'll browse the manvon flobo79 - Prusa i3 and variants
Moin allerseits. Das Problem ist, dass der Feeder vom 2. Extruder nicht anläuft. Ich starte den Loading-Vorgang, er heizt auf, erreicht seine Temperatur, auf dem Display erscheint " .. feeding now blabla ..., press to stop" aber der Feeder-Motor geht nicht. Hat jemand einen heissen Tip für mich wo ich mal schauen soll? Drucker: ich habe einen Berlin i3 mit Rumba Board mit Merlin drauf im Einsvon flobo79 - Prusa i3 and variants
Moin allerseits. ich habe einen Berlin i3 mit Rumba Board mit Merlin drauf im Einsatz - ausgeliehen. Der machte auch ein paar Tage lang was er sollte. Nun stoppt mitten im Druck - nach ca 15 Min - die X-Achse aber der Rest druckt fleissig weiter. Auf dem Rumba blinkt die LED HE0 heftig, aber ich kann im Netz nichts finden, was das heissen soll. Hat jemand einen heissen Tip für mich?von flobo79 - Allgemeines