Yes I know and I already had a short circuit on 5V. But the board was fine after that. A good feature. It can't be a wiring failure because everything works fine with ramps and the first board was grilled with only 12V.von JuculianD - Controllers
I HATE THIS F****** BOARD. I now have 2 units broken. First, the board started smoking when turning on on 12V. 3DSWAY said, its my fault and I need to buy a new one. I was really pissed of and bought a new one without display for around 100$ (the stepperdrivers all burnt too...). The new board then worked fine, but I had maaaany bugs in the firmware. First, the endstop doesnt wont to work when covon JuculianD - Controllers
It would be very nice to customize language and logo myself. But thats the problem with cloused source. I already got some sucesses with changing the boot logo, but it looks distorted .von JuculianD - Controllers
Thanks for the answer! I've already connected everything as it should and the software is set correctly. But it doesn't work . It makes the self test and then stays with pin up.von JuculianD - Controllers
Hello! I have a lerdge board since 4 months. I've had many problems and also broke a board, but now it works. I have a bltouch but the pushpin doesn't want to push out when the board wants it to. Please help me with the BLTouch D:. Also, could you please send me the new firmware because I don't want to wait.von JuculianD - Controllers
Danke Walter . Wie sieht es denn aus, wenn man einen größeren Kondensator anlötet?von JuculianD - Elektrik & Elektronik
Danke für Deine Antwort. Genau das möchte ich machen, die Pins auslöten und anstattdessen Kabel zum Boost-converter der vor 5 Minuten angekommen ist. Dann kann ich auch 24V oder mehr an die Treiber geben. Soll ich mir dann diese Elkos mit dem längerem Bein an VMot und dem kürzerem an GND? Entschuldigung für die Nachfrage, ich habe noch nie mit Elkos und ähnlichem gearbeitet. Ich hoffe auch, dassvon JuculianD - Elektrik & Elektronik
QuoteDemos Quotelukie80 QuoteDemos ... Jetzt werde ich mir erstmal die Karten legen müssen ob ich neue Stepper kaufe die vielleicht nicht fiepen oder ein neues Netzteil und kompatiblen Controller mit 24V. Oder die Pins der TMC2100 für Vmot nicht ins RAMPS sondern nach oben führen und mit einem DC-DC Wandler (Ebay ~10€ ) versorgen. Aber dabei nicht vergessen 100µF Kondensatoren zwischen Vmot und Gvon JuculianD - Elektrik & Elektronik
Hallöle! Mein Drucker hat jetzt frisch LED's bekommen (Gerade 8 Strips -> 2 an jedem Profil an den Drucker verbaut). Diese sind jetzt noch an das Netzteil angeschlossen, das möchte ich aber ändern. Es sind zwar RGB LED's, diese sind aber vorerst zusammen gelötet -> Weiß oder aus. Da ich aber beim Ramps kein Heizbett dran habe, ist der PWM Pin D8 noch frei! Wie kann ich das ansteuern? Es givon JuculianD - RAMPS Electronics