Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
I am having trouble with my prints distorting about 1.5mm above my heated bed. I am using a Prusa Mendel reprap with a .5mm hot end. I print on glass smeared with ABS juice. My bed is running about 108 to 110 degrees C. I print with a hot end temp of 215. On larger prints the print adheres well and prints well but by the time it gets finished, the layers about 1-1.5mm from the bottom seem to shri
by
oldboatguy
-
Printing
I'm a newbie trying to sort out problems getting parts to stick to the print surface. I have a Prusa running Gen6 electronics, Sprinter firmware, and Pronterface. I have successfully calibrated the x,y,z and e steps and can print small parts on blue tape without a heat bed. I added a heat bed and got larger parts to stick but after about 10 layers, they start to sag. I then added a switch to the
by
oldboatguy
-
Reprappers