Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
I added a 80mm PC fan and the print came out fantastic!
Thanks again!
Telly
by
0telly0
-
Printing
Hello, ive been doing the .5 mm cube wall print with good results. I have only a small problem. As the print progresses the layers become uneven fininsh for some reason. Here is a picture
So far ive adjusted layer hight between 0.25 and .4 and dropped my hot end temp form 200 to 185. Hot bed is running at 60. But i get the same results if i get a good ish print. Runnig a .5mm hot end too.
I'
by
0telly0
-
Printing
Solved. The E mm/min was set to 5 in pronterface. Got my first test prints tonight! Woop!
by
0telly0
-
RAMPS Electronics
Hello, I've been having problems with my E0 stepper for a bit of time now. It turns very slowly and vibrates a lot. I've ran the 1.4 test firmware and it runs fine using that. In sprinter firmware I've messed about with steps per mm, acceleration speed and max ecceliration speed but still haven got anywhere. All my other axis are calibrate and running great. I've even changed the pin out in pins.
by
0telly0
-
RAMPS Electronics