Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
Hi Guys,
Been building a prusa i2 for months now. Manage to calibrate x, y, z but im struggling with my extruder. My extruder keeps on jamming. It would run and start to melt the filament but after a few millimeters of filament, the motor and the hub bold with starts to chatter or jam.
Settings:
Wades Extruder 0.5mm Nozzle 3mm Filament Temperature of Extruder 185deg
Ive tried adjusting the
by
kevman12
-
Printing
Hi 3dKarma and Peterxm,
Thank you for your reply guys! Thank you for the link! That is exactly what I was looking for. The Ramp board I have is the Ramps 1.4. The Nozzle I have is only for a single extruder. I am so happy that I can see the wiring diagram from the link.
Thanks Guys!
by
kevman12
-
General Mendel Topics
Hi,
Just bought a Prusa Mendel i2 kit. The kit contains a Budaschnozzle Hot end, does anybody have any instructions on how to connect the wires?
Regards,
Kev
by
kevman12
-
General Mendel Topics
TheRevva Wrote:
-------------------------------------------------------
> Hi Kev,
> I too am very new to the reprap scene and have
> just started gathering all the bits for an i3.
> I'm in Sth Auckland - rural Pukekohe area so if
> you happen to go the route of an i3 and / or are
> anywhere in the area, I'll do whatever I can to
> assist.
>
> In my case, I wanted to so
by
kevman12
-
New Zealand RepRap User Group
Hi All,
I'm new to this user group. I joined as I would like to build a Reprap 3D printer but don't know how. I saw some articles online but abit nervouse in regards to the software side of things.
I live in Auckland and hoping I can get some assistance, mentoring or any material whatsoever to get started e.g. were to begin?, where to buy? - trade me?
Is it worth it? <--- is it better to b
by
kevman12
-
New Zealand RepRap User Group