Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
thanks this the suggestions. I did some more calibration today and will try another print tomorrow of the same file. hopefully i can get this print right. I will post the new pic tomorrow I'm sure
by
horizonleatherco
-
Printing
would it be too much to ask for you to post a picture of this printer I'm very curious to see it I am unfamiliar with that machine aswell.
by
horizonleatherco
-
Reprappers
hey there I was just wondering if anybody had any tips or has seen this problem before both of these things were built at the same time on the same palette and one has bubbles I can't figure out for the life of me what is causing this because one has a perfect print and the other seems odd
and just so you know I'm running a DIY raprap i2 with ramps 1.4 and the print was set at .2 layer height an
by
horizonleatherco
-
Printing
hey there I'm building a RepRap I2 I've been building for about 4 months and I've been printing now for about one all I can say is it seems 1.75 filament is easier to come by and most people are switching over from 3 millimeter. as for the extruder who knows I'm using a direct drive that I found on ebay and it works sometimes I'm having more issues with it than anything else now for your firmware
by
horizonleatherco
-
Reprappers
hello out there I am putting word out to all of the local Santa Cruz and Monterey areas of California looking for locals who do 3d printing I've been working on my printer for about 4 months and I'd like to find others in my area that are into it as well. Also I am looking for any info on local events.
Thanks
by
horizonleatherco
-
Reprappers