Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
I've used Cura a lot, then came back to Slic3r because of this, but after printing some fairly important prints I've decided to switch back to Cura. Why? with Slic3r layering was better (hadn't had so many oscilations) but it left a lot of holes in prints. Where circle met sharp edges and so on. However retraction there is controlable better than Cura. But I'm more willing to cut the strings awa
by
Vandalas
-
Printing
Hey guys!
I have Ramps compatible smart LCD like this but I have a problem with a control knob. I have already replaced it two times and it still went off. So I have decided to make a 3 button conversion instead of that knob. However I haven't managed to find any of circuit schematics of that lcd controller. Have you any ideas?
by
Vandalas
-
General
Yeah, but any ideas how to fix it? At nozzles threaded part there is some sort of O ring to seal it, however it does not help as you see.
by
Vandalas
-
Printing
Hello, folks!
I was unable to find one or searched bad for the topic like this
My prusa i3 has a little problem. While printing hot plastic somehow manages to flow through screwed joints.
Maybe E axis steps/mm is too big? However as I'm adjusting it looks like to have no influence.
by
Vandalas
-
Printing