Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 12 of 12
Thanks guys i will check that out.
by
reggie83
-
Reprappers
I didn't tried Luzlzbot as yet but i will give it a go. I am building similar printer to Taz but with a lot of upgrades so i am making custom parts and need those inserts
by
reggie83
-
Reprappers
Hello All,
I have been having very hard time to obtaining brass inserts in UK used to build Lulzbot Taz printer and I wonder if somebody from UK found some supplier for those?
Many Thanks.
by
reggie83
-
Reprappers
Thank you i will check belts
by
reggie83
-
Printing
Hello All,
Could somebody tell me why if it is a solid wall results OK but where it is a hole results not that great... please see a picture.
by
reggie83
-
Printing
I coundnt end stop to triger unless it is min but when i make it max it dont work..
by
reggie83
-
Reprappers
That brilliant i will give that a try in the morning what did you changed in firmware?
by
reggie83
-
Reprappers
I didn't found solution yet still trying to figure it out..
by
reggie83
-
Reprappers
but if i do that it says it is triggered always doesn't matter if it pushed or not..
by
reggie83
-
Reprappers
Hello,
Marlin firmware
My prints cumming out mirrored so did some investigation and switched some things around, but the problem at the moment my X end-stop is not triggering.
The situation is:
X axis endstop is on the left (would like to keep it on that side) set as MAX wired as MAX X on ramps (the one not triggering) movement direction is correct pressing X+ it moves towards endstop.
Y axis
by
reggie83
-
Reprappers
Thanks for advice I will calibrate my extruder on a weekend.
by
reggie83
-
Reprappers
Hello,
I am very new to 3d printing but I just finished building my prusa i3 with E3D V6 1.75mm direct hot end. When i was trying first print at first looked ok but it wasn't the hot end was sort of scraping layers and it looked like it try to put layers very close to each other and I left it for few more minutes and digging in to layers was even worse.. So I would like to ask for advice where
by
reggie83
-
Reprappers