Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Is there a way to reduce the travel of the z axis during the start of the print? The reason I am asking this is because I have an incredibly slow z axis, that has to reach the end stop, go back up, then down and touch it again, then it goes back up, then down, to finally print. This whole process take 10 mins. Is there anyway in the firmware to reduce the amount needed to travel or remove the unn
by
trbjr
-
Printing
Hello,
I am in the final process of building my scratch build 3d printer and am stuck configuring the hot end thermistor. I do not specify know the type of thermistor I have but am currently using 5 in the firmware. Here is the link to the hot end . When I connect to my printer I get this error
Error:MAXTEMP triggered, system stopped!
Heater_ID: 0 Error: Printer halted. kill() called!
I beli
by
trbjr
-
Reprappers