Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Curious if anyone has a link to a complete list of board designation numbers for firmware. Looking to switch over to the Mega 2560 but when defining the supposed number in firmware it is coming up with pin issues or other issues, meaning they are not the correct number designations. Have tried 80, 701, 801, etc and still "issues" pop up in board designation, so apparently these and others are n
by
hugetoughguy
-
Printing
Hello,
I'm having problems getting ANYTHING to heat properly on my 3D printer. I am using a kessel mini style delta 3D printer driven by a 360W power source running through a melzi pro board. The board is not supposed to be complete junk according to users, but I am on my 2nd board now and still the same problem. With the power level of my power supply I should have zero problems but am still
by
hugetoughguy
-
Printing
Excellent, thanks so much. I appreciate it very much!
by
hugetoughguy
-
RAMPS Electronics
Here is the new board the melzi pro
Here is the old connector
Here is the new connector for the same endstop
Here are my endstop types
A closer detail of the endstop wiring
So what are your thoughts on connecting the 3 wires to 2 terminals?
by
hugetoughguy
-
RAMPS Electronics
I'm having a problem with a melzi board replacement. My old board was garbage from the manufacturer so I had to purchase my own. Upon the new board coming, the 3 prong terminals have been replaced by 2 prong terminals for the endstops. How do I connect a 3 wire endstop to a 2 wire terminal? Is there any way? I have a VCC, ground and signal coming from the endstop and the board only has 2 conn
by
hugetoughguy
-
RAMPS Electronics