Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Hello ggherbaz,
I increased the shell thickness to 1.2 (0.4 x 3) with speed 40 the print was near perfect, just the layer shifted (Clip 1.jpg). Then I tried 1.44 (0.48 x 3) with speed 50, the quality wasn't good (Clip 2.jpg). Now I am having different problems, I have attached few more images of prints for your reference:
Batarang with Shell 1.2, top/bottom 0.8. Problem: Gaps in top layer
Cable p
by
xhm
-
Printing
Hello guys, as you guys suggested, I calibrated the extruder, changed from 270 to 100 E-steps(I don't know why I had to do so much). Also changed the flow rate to 100%, Shell thickness to 0.8 mm, top/bottom thickness to 0.6 (no separate setting in cura), Print speed to 40 mm/sec. Now the quality is much much better. Thanks ggherbaz and Floyd. Now there's one problem, the flat sides are having lit
by
xhm
-
Printing
@ggherbaz Thank you for the tips. I'll tweak these settings and will revert back. Regarding flow rate, more than 70% extrudes a lot and nozzle starts touching the print after few layers. I guess extruder needs calibration. I'll do that also and will get back.
by
xhm
-
Printing
Hello,
After solving all my printer issues, I have been trying to improve my print quality. But as of now I am stuck and confused what settings needs to be changed. The problem looks like over extrusion from some angle and under extrusion from some angle. Also there are other problems also, which I am not able to understand. Please have a look at the images and help me out. Thanks.
Settings:
Noz
by
xhm
-
Printing
@MCcarman: It was working perfectly, then suddenly 2-3 days back this problem started occurring. I haven't touched the firmware. It was pre-installed by the seller. I have tried it with Cura and repetier, both are giving me same problems.
by
xhm
-
General
@ShankMan: There's no such line. I have attached an image of G-code. Please have a look.
@Icefire: I am using Marlin firmware. I am using Cura, I tried doing it with repetier, but I was facing another problem with that. The extruder was going up before print and was extruding atleast 50 mm away from the bed.
by
xhm
-
General
Hello,
I am having a very weird problem in my Prusa i3. While starting the print the nozzle goes to X,Y,Z home (the corner), at this point the distance between nozzle and bed is perfect. Now to print, the extruder moves towards the print location but also simultaneously goes down (with the help of z motors). The screw puts excessive pressure on the Z end stop. The nozzle gets blocked because its
by
xhm
-
General