Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Ok cool thanks for the info I think I have all of this stuff I'll give it a shot tomorrow and update this with what happens.
by
Chromewrecker
-
Printing
Thanks for the info I removed the shims to see what happens. The extruder will push a little out then stop its odd cuz it seems to push when going from the left to the right back by the home corner and when it hits to far away it stops until it reaches the home corner again. I tryed to print a large square just to see what would happen. I checks all the connections and wiggled the wires to see if
by
Chromewrecker
-
Printing
yes I install the filament in the air no back pressure. I don't really see any issues with the idler wheel and I have remove the hot head cleaned the nozzle and the wheels. I checked the connectors seems to be plugged in all the way and don't see any burn inications.
by
Chromewrecker
-
Printing
update I have removed the sticker off the front of the filament stepper motor and drew a black on the shaft. When I select the load filament option on the printer the black line spins and the filament extruds. when I select a print I tried one pre loaded on the printer and one downloaded from thingivers the black line no longer spins but rather jogs back and forth and the filament will not extrud
by
Chromewrecker
-
Printing
Ok so not really sure what happen but everything was fine until last night. I was in the middle of a print and messing with the computer when a video card error popped up and the computer froze. After a minute of the screen flashing on and off the repetier host was not responding and the print stopped. Was I reset the computer and the printer I retried printing the file it started off fine so I w
by
Chromewrecker
-
Printing
ok so heres the update I have removed the sticker off the front of the filament stepper motor and drew a black on the shaft. When I select the load filament option on the printer the black line spins and the filament extruds. when I select a print I tried one pre loaded on the printer and one downloaded from thingivers the black line no longer spins but rather jogs back and forth and the filament
by
Chromewrecker
-
Repetier
Ok so not really sure what happen but everything was fine until last night. I was in the middle of a print and messing with the computer when a video card error popped up and the computer froze. After a minute of the screen flashing on and off the repetier host was not responding and the print stopped. Was I reset the computer and the printer I retried printing the file it started off fine so I w
by
Chromewrecker
-
Repetier