Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
Hello from Germany,
it started, that the frontside fan didn't worked. So I changed it.
Still problems. After that, suddenly "no connection" to the
printer via USB. Printing from SD-Card also not possible.
At the frontside panel I can do "homing" preheat etc., but printing
is not possible. Can someone help me?
Thanks, regards, Erhard.
by
XStein
-
General
Thank you, yes the fan in front is working. The fan on the left starts delayed.
I try to change the extruder!?
Thanks, regard, niche Christmasdays, Happy New Year, Erhard
by
XStein
-
Printing
Hello from Germany, I have a Makerbot 2 Printer. He starts wonderful, but suddenly
he prints "into the air" - no filament visible. When I stop the print, I find out, that
the filament ist in the extruder building a little node around the little "gear" in the
extruder. I completely cleaned it several times, changed the nozzle, but...
See the picture. Perhaps someone has a an idea.
Thanks, regards,
by
XStein
-
Printing
Good Morning from germany,
I was not sure to be able to change the firmwire. But thank you very much. Because
I had an old transformer, I build an independent "heatbed-supply", it works.
Best regards, Erhard.
by
XStein
-
Printing
Hello, thank you very much. I tried everything and followed the instructions, you send me.
Choosing as the Device the Replicator 2X from the menu from the newest version of
Makerbot Desktop, I have the problem, that after done the settings, the Printbutton is
not activated, so I can't start the print. What I noticed, there is no possibility to set a "hook"
in the menu "Heatbed on", in this Versio
by
XStein
-
Printing
Hallo, ich habe meinen Makerbot 2 mit einem Heizbett ausgerüstet.
Am Gerät kann ich es aktivieren und "vorheizen". Leider ist es so, dass
ich beim Drucken fetstellen muss, dass die Temperatur am Heizbett nicht
gehalten wird, nach dem Vorheizen wieder abfällt. Ich drucke mit Makerbot.Desktop.
Immerhin habe ich es, mit Hilfe, geschafft,dort das Heizbett "zu sehen". Werte können
eingegeben werden.
by
XStein
-
Druck- und Heizbetten
Hello from Germany, I just installed a hetbead on my makerbot replicator 2.
I can preheat it on the dervice exaktly, but when I start printing, the heatbed
will not hold the temperature to the end of printing. After reaching 65 degrees
Celsius (preheating) it cools down.
Thanks for help, regards, Erhard.
by
XStein
-
Printing
Hallo, ich bin zwar erfahrender Bastler, aber habe ein Problem: Ich habe meinen Replicator 2 mit einem Heizbeitt ausgerüstet. Dieses wird erkannt und ich kann es "vorheizen".
Leider ist es so, dass während des Druckes die Temperatur abfällt. Ich benutze Makerware-Desktop, wo auch das Heizbett auftaucht. Ich habe keine Ahnung, was ich machen könnte.
Auch der Versuch, mit der alten Makerware 2.4. w
by
XStein
-
Elektrik & Elektronik