Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
I as hoping someone may have an idea for slicer setting / workaround that might help me to solve this issue.
I have designed a large cartesian grid with circular outline in SketchUp. The plan is to print about 15 of these, stack them and run M5 nylon threaded rods through the length of the object.
I have tried a couple of different slicers (Cura, Simplify3D) and get the same issue; when layin
by
statejon
-
Printing
I recently received a pre-assembled E3D-V6 hot end to swap in for my Hexagon.
I connected the thermistor and heater wires exactly as for the hexagon (thermistor to T0, heater wires to D10) and switched on the printer. The initial temperature seemed accurate (20 degreesC), but instantly the temperature reading was climbing up, despite the fact the 'target temperature' was 0. Indeed the little red
by
statejon
-
RAMPS Electronics