Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
THANKS...Really appreciate your reply! This has been the most helpful information I have received to date. It helps me more clearly understand the purpose Feedrate and Acceleration. I made the changes and SUCCESSFULLY printed the 20x20 test block provided earlier!
Appreciate the tips, but I have not yet enabled EPROM, but can definitely see where that would save tons of time, especially now
by
MustangR
-
Printing
Ok, retrieved the calibration cube you provided and went through the calibration steps. All of my axis' (XYZ) are moving the correct amount when exercised (i.e. 1mm, 10mm steps) and homing. I checked Y axis belt tension, and others, and all seem to be in good order. Attached is latest attempt at the test cube you provided and latest config files. Thanks again to the group for any help/guidanc
by
MustangR
-
Printing
Wow...chalk that up to old man eyes. Attached configuration.h. I did however make several changes from stock firmware, of course the normal LCD/drivers, etc. and then mostly dealing with speeds xyz (had been a significant challenge for me getting max accel/feedrate/jerk/etc), and setting endstops up properly...and of course, assuming I even have these settings correct.
After I posted, I used a
by
MustangR
-
Printing
Ok, NOOB alert...I have just recently completed...I think...configuration of this recent purchase of a Prusa i3 running Marlin 1.1.9.
I have successfully configured endstops (xyz) and homing is working correctly.
The problem I am having is when I print the attached gcode from attached .stl, the attached picture is what I have been getting.
It appears the z axis only prints the first 6 or 7 layers
by
MustangR
-
Printing