Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Yes indeed the 4k7 pull-up resistor on the RADDS board is damaged/missing after i practiced my soldering skills on it... a new RADDS is already ordered and on the way.
by
passion43d
-
Printing
Hello Pippy,
Thanks for taking your time. I recently unwired the board and checked it again for any visual clues of faulty solder or burned components and there are none.
I measured the DC voltage of the thermistor pins on the RADDS and oddly, T0 reads 2.2 Volt while all others are around 3.10 - 3.17 Volts.
Any ideas what causes this odd reading?
by
passion43d
-
Printing
Hello Community,
Recently i "finished" building my second 3D Printer and i managed to print a 15 hour print with no problem.
Sadly the success lasted only about 2 days. Please help, SOS, MAYDAY...
Hardware:
COREXY format, Original Arduino Due, RADDS 1.5, TMC 2130 for X and Y, NTC 3950 (Termistor table 11 in Marlin 2.0), 400W silicon heated bed with SSR,
Software: Marlin 2.0 (32 bit)
Issue
by
passion43d
-
Printing