Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
Ok, thanks, that explains it.
Chipmunk
by
Chipmunk
-
Slic3r
The dimensions are aproxemately 4x4x8cm
The Pictures are for 0.4mm, 0.2mm 0.1mm and 0.05mm layer height.
Infill density is set to 10%, I changed only the layer height.
Chipmunk
by
Chipmunk
-
Slic3r
Because, where I get a nice raster for e.g. 10% infill at 0.2mm layer height, the raster degenerates to just one line when setting the height to 0.05mm and gets near solid when setting 0.4mm height.
At least the preview displays it this way.
Chipmunk
by
Chipmunk
-
Slic3r
Dave
That supports my statement: If I ONLY change the layer hight, why does that change the density of infill pattern?
By the way Slic3r is the only slicing program that does that and it is not logical.
Chipmunk
by
Chipmunk
-
Slic3r
@ Mikk36: The extrusion width for infill is zero
@Dmould: That is not logical, as a thinner layer should result in less material deposited per layer - 0.1 mm should deposit half as much material than 0.2 mm per layer
Otherwise the width of the deposited filament would be doubled for half the layer hight which would result in incorrect dimensions.
Chipmunk
by
Chipmunk
-
Slic3r
Hi,
I am experiencing unexpected behavior in Slic3r when I change the layer thickness.
The finer I make the layer the less infill I get. I am not changing the Infill percentage!
0.1mm Layer height gives 50% less infill than 0.2mm. 0.05mm has again 50% less infill
Why is that?
Chipmunk
by
Chipmunk
-
Slic3r