Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
I have a couple dozen printer/print/extruder configurations across multiple computers that I want to clean up an consolidate. I can set up network access for the configs (as per the Slic3r manual) but I would first like to clean up the profiles I no longer use. Where are these configs/profiles stored?
by
wannathermal
-
Slic3r
I have been using DC42's Mini Differential IR height sensing board successfully for a while but yesterday I did some maintenance on my printer and the probe no longer works correctly.
I get the 4 flashes on startup but the sensor readout on the Duet 2 board stays at 456 for the z probe readout, the LED lights when I put a surface close to the probe but the readout stays the same. Any ideas"
M558
by
wannathermal
-
CoreXY Machines
The Replicapes are Rev B3 and B3A, the B3 was purchased in May and the B3a in November 2016.
These were used for my daughters Computer Science project in school. The Beaglebones were purchased at the same times.
120€ for the B3A+BBB (plus shipping)
100€ for the B3+BBB (plus shipping)
by
wannathermal
-
For Sale
When you say full stepping, what do you mean?
by
wannathermal
-
General
I have got my F3D mounted and other than under-extrusion problems it works great!
by
wannathermal
-
General
Well I am using a Replicape board and right now I i'm using 1/16th stepping. I haven't figured out how to do 1/8th stepping yet. And 120 steps/mm is quite low. That is te problem. I think the problem is in my Redeem configuration.
by
wannathermal
-
General
So I have my F3D drive installed with a E3D V6 hotend and other than a few problems with installing (thanks Mutley3d for the great support) I am very happy. Printing a calibration cube works well. I am having a problem with under-extrusion. The size of the cube is very close to correct, 20.03 X 19.89 but there is noticeable lack of plastic on the top and bottom of the print, you can see through t
by
wannathermal
-
General
When will the web site be updated with instructions? I will be mounting the drive in the morning. I designed a mount for my I3 and will be testing soon. I will need some guidenline as to speed and stepping.
Bob
by
wannathermal
-
General