Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Hello,
I am attempting to compile Repetier-Firmware 0.91 (Rev 4 config) for a Gen7 1.3.1 board using an ATmega644 @ 20mhz.
I am using the Arduino 1.0.5-r2 IDE under Windows 7 x64.
I have the most recent Gen7 board files from the Gen7 git loaded into the IDE.
I have motherboard type 7 selected in the configuration.h
The error that I receive while compiling is:
In file included from /Repetier.
by
HeK
-
Repetier
I have had very good luck with an Antec Basiq VP350 ATX power supply.
I paid $30 Canadian for it. It advertises two 18amp 12v rails.
While I had it running my J-Head mk iv hotend and PCB heated bed off one 12v rail (Molex), I cut off one of the four-pin 12v connectors and crimped on another 4-pin molex to run my bedplate and make use of the second rail.
by
HeK
-
Next Wave Electronics Working Group