Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Thank you so much!
What finally got it working for me:
HAL::i2cInit(100000L);
HAL::i2cStartWait(4 << 1);
HAL::i2cWrite('a');
HAL::i2cStop();
I appreciate your pointers, thank you!
by
mlapaglia
-
Repetier
Hello! I am using repetier on a rambo and want to use the i2c capabilities for communicating with another Arduino.
I uploaded an example sketch to the rambo and another arduino and have them talking to each other fine. When I try to add this into the Repetier firmware I get trouble.
I have a simple example:
HAL::i2cStartWait(4);
HAL::i2cWrite('a');
HAL::i2cStop();
This code fails when it gets
by
mlapaglia
-
Repetier
I'm looking at doing this as well. We could use something like this only modify the version that is going onto the carriage to hold two of them instead of one. We'd need to modify the carriage to have two holes instead of one. Or
by
mlapaglia
-
General Mendel Topics
That is nice! I'm waiting for my misumi order to come in, a nice extruded case with some plexiglass I'll probably put some lights in the corners for a nice effect.
Might have to take it apart and paint it.. That looks good.
Got a raspberry pi and octoprint up and running last night, watching from work is a distraction for sure:
by
mlapaglia
-
General Mendel Topics
Look what came in the mail finally!
My Makerfarm Prusa i3 8" 3D Printer
Content included
* Bag with screws, nuts, washers, etc.
* Rods
* Hot end assembly, I selected the J-Head 3mm filament .35 nozzle size hot end.
* Bag with wires, linear bearings, and cable for the stepper motors.
* Roll of kapton tape
* Bed-leveling kit (not to be confused with an auto bed-leveling kit)
* USB cable
* 5
by
mlapaglia
-
General Mendel Topics