Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Thanks for the help and information. So i changed the pin assignments per your recommendation, and now the second extruder wont even turn on... thoughts?
by
eroderz
-
General
Hi Everyone. Im trying to setup a dual extruder on my Rambo V1.1 board. The second extruder does not run independently and heats up when the first one does. As shown in the picture, It should be set to 0, but is running much hotter. I beleive this issue has to do with the pin connectors. but i am unsure what to set the value to... can anyone tell me what i should set the pin connector values to?
by
eroderz
-
General
Does anyone know how to remove your old Slicer presents in the pull down menus? During development i had so many files to keep track and now there are way too many. Please
by
eroderz
-
General
When i updated to V0.95F, and i try slicing a file that ive loaded, I get an error saying
Generated G-Code Not found
"i could not find the generated G-Code file.
Possible reasons
-The slicer had an error and did't finish slicing. check log output
-the sliver stored the file with an unexpected filename
Help please!!! I didnt have this problem with the last version...
by
eroderz
-
Repetier