Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Have you tried just heating up the extruder by itself? Just to narrow down the cause. Or does it only happen when heating both?
by
tonyallen28
-
Repetier
Trying to use some servos and gcodes to auto eject my prints after they're done printing. I've read alot of posts about M190 waiting for bed temp whether the desired temp needs heating or cooling however it doesnt seem to wait for cooling. Going through Commands.cpp I was able to change this line
while(heatedBedController.currentTemperatureC + 0.5 < heatedBedController.targetTemperatureC &am
by
tonyallen28
-
Repetier
After reading through a lot of the posts looks like what is needed is conditional statements implemented in the Custom G-Code section. ex: IF == XXX THEN M140 S0
However until that is implemented looks like I will be doing it manually like the_digital_dentist suggested.
by
tonyallen28
-
Slic3r
Looking for help making a script that turns the heat bed off aprox. 10 mins before the print finishes. That way I can easily pop it off the bed. If unable to do this based off of time then turning the bed off at a certain layer could work as well. Maybe this is a setting somewhere that I overlooked? Any help would be greatly appreciated.
by
tonyallen28
-
Slic3r