Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Mr Alvin, May I thank you for contributing to our query!
We came across products produced by Staticboards Spain and ordered their special Ramps 1.4 board, DRV8825, and TMC2130 for trial.
The Staticboards ramps 1.4 worked seamlessly. The DRV8825 also worked seamlessly. The quality looks impeccable, however the TMC2130 behaved erratically.
When I mean erratically, i mean that if you change th
by
Mendelevium99
-
RAMPS Electronics
Hi Guys, We are producing a 3d printer based on the Ramps 1.4/Arduino Mega 2560 board.
Can somebody point us towards a good quality Ramps supplier? Recently Tried and Tested Staticboards and the product was quite decent... BUT they informed us that they are discontinuing production of their boards.
Chinese clones are a disaster. Bent pins, shorted soldering, the list is shameful. When we tes
by
Mendelevium99
-
RAMPS Electronics
Hi Guys, I am stuck.
I am buiding a dual extruder printer using a ramps 1.4 board and run by Repetier firmware and I bought a reprap fan extender.
Could somebody help me how to configure the repetier firmware to possibly command each fan?
I need advise how to configure the lines in the firmware as well...
The second line I tried also to put the value to 9 but there is no response.
I am using M10
by
Mendelevium99
-
Repetier