Hope i am in the right forum ! I need help thats for sure i try to load Marlin into my Board its a Rumba i have the device loaded into device manager serial port 12 i use aurdinio 1.6 and Marlin for my TK300 printer I open and i use config,h But when trying to verifye i get forbidden reg name etc and it stops What have i forgotten ` i manage to build everything i want but i am still useles abouby ballebam - General
Hope i am in the right forum ! I need help thats for sure i try to load Marlin into my Board its a Rumba i have the device loaded into device manager serial port 12 i use aurdinio 1.6 and Marlin for my TK300 printer I open and i use config,h But when trying to verifye i get forbidden reg name etc and it stops What have i forgotten ` i manage to build everything i want but i am stillby ballebam - RepRap magazine
I am also going mad abóut A rumba card i had marlin in it but every distance become 5 times too long in repetier host x manuel 10 mm got more than 50 mm 10 mm become 100 mm where to change i have TK 300 LOOKSLIKE LUZLBOT TAZ 4 BIG BELTWHEEL 36 I THINK THE FIRMWARE WAS MADE FOR A BELTWHEEL WITH 12 RIBS.by ballebam - RAMPS Electronics
WHEN POWERUP 2 red leds are lighting and led contrroller beeps and blinks, repetier connects but no sign of life in manually mode.by ballebam - RAMPS Electronics
I have problem with my rumba board TK300 PRINTER just finished the kit when n POWER ON 2 RED LEDS are lighting no blue led one left high and one on a separate board besides the mosfet board Repetier connects on com 3 and goes to idle in manually mode but nothing more happens the led controller blink and beeps what to do i took away the endstops -x-y-z red where in The middle and black very doby ballebam - RAMPS Electronics
just a little olive oil !!by ballebam - General