Hello, Im using electronics : Azteeg x3 V1.1 drivers : TB 6128 (omc.stepperonline) motorrs : NEMA 23 on 2,4 Amp phase firmware : Repetier firmware V0.92 host : Repetier host trough usb to board My problem is that when I print or move freely XY the motors do movement and stepping correctly but when the move ends the motor goes a small bit back, seems to me that the drivers dont hold position coby Megane008 - Printing
Dobrý den, Prodám buildplate od GeckoTEK o velikosti 220mm x 220 mm. Jedná se o magnetickou hliníkovou desku s vrchní HT vrstvou. Bohužel mi omylem zaslali místo kruhové na delta hranatou takže mi je tato k ničemu a rád jí prodám. Ze zdola lze nalepit silikonová topná rohož případně použít jiné vyhřívání. Povrch je vhodný pro tisk ABS a PLA bez deformací. Více u nich na webu. Původní cena $119.0by Megane008 - Prodám, koupím / komerční nabídky
Ahoj prosím o vyplnění kdo si najde chvilku chceme zjistit jak je to s plasty v ČRby Megane008 - FAQ & HOW-TO a odkazy
well if you use J-head you can, you need to heat up to 250 for ABS and then you need strong stepper motor on E, Im using my own build direct drive with nema 23 driven by TB6560 drivers which give rly high torqueby Megane008 - Firmware - mainstream and related support
Thanks a lot for help yesterday I downloaded new version of Marlin and whoala it works without problems even with TB6560 drivers. So if you want I can document it and post it somewhere so you can see for yourself that TB6560 arent so bad for me they work just fine and give me power I need for Z and for extruder so I can push 3MM fillament on 200 mm/min speed:-)by Megane008 - Firmware - mainstream and related support
Hello, I have a big problem with setting up Marlin to work with my version of printer. my specs: Arduino mega 1280 + Ramps 1.4 Im driving X,Y with Arduino + Ramps 1.4 and stepsticks drivers works properly Im driving Z with Arduino + Ramps 1.4 and from Ramps 1.4 I have connected coresponding pins #define Z_STEP_PIN 46 #define Z_DIR_PIN 48 #define Z_ENABLE_PIN 62 by wire to bigger drivers on Tby Megane008 - Firmware - mainstream and related support