Yeah Finally I resolved the problem... if the cable of ground is long the valors change some And 12V in the wiki say that is a bridge that I must cut.by Howarto - General Mendel Topics
Hi, I have a problem with my Prusa Iteration 2... This problem is that the temperature up when the hot-end stop and when hot-end start the temperature decline... For example... the temperature arrive at 240ºC and the firmware stop to keep... then, the temperature increases. When the temperature up the temperature decreases 30ºC... The difference is always the same... I saw that 12V expansion pby Howarto - General Mendel Topics
Hi, I have a problem with my printer... The problem is that the height of the figure is lower than the real piece. In the cube of calibration of 20x20x10 I have 9'3mm of height. I use Marlin + CURA Someone has this problem?by Howarto - Reprappers
Scanvs good job! Now, I can upload sprinter in Sanguino Sincerely...thanks for the great helpby Howarto - Sanguino(lolu)
Hi, I build the printer Prusa2, but now, I try to upload Splinter with the arduino IDE 022 + sanguino023r4 and arduino IDE 023 + sanguino023r4. In this IDE the compilation is good, but when I upload arduino say: "Binary sketch size: 16426 bytes (of a 63488 byte maximum) avrdude: stk500_recv(): programmer is not responding avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x48" I seleby Howarto - Sanguino(lolu)