i just checked the logic of end stops and this is what i got hold none and then hold each one down. >m119 SENDING:M119 Reporting endstop status x_min: open y_min: open z_min: open >>>m119 SENDING:M119 Reporting endstop status x_min: open y_min: TRIGGERED z_min: open >>>m119 SENDING:M119 Reporting endstop status x_min: TRIGGERED y_min: open z_min: open /** * Marlin 3D Printeby dfrogy - Printing
i am having problems homing my printer please watch the video. used your marlin config to set it up. now this is a folgertech printer that i build 2 year . saw your prusa I3 clone builds so i had to do it too my printer. if you can help with homing problems that would be greatby dfrogy - Printing
QuoteRiaanLR I am also having this problem. Printing on blue painters tape. Sits great for small prints but the longers ones come lose on the edges. ABS, 3mm, nozzle .4mm, layer thickness.3mm, all layers .3mm, Printing slow at 30mm/sec for the bottom layers. Should i bring down the bed heat or increase after the first layers. current temp 100 degrees for complete print. Riaan i don't use bluby dfrogy - Reprappers
Quoterich1812 It happened to me as well. I found that keeping the bed temp lower (I keep it around 65-70C, seems to help, also I applied a thick even coat of hair spray on a clean bed, wait for it to dry, , then before I print I spray more on the corners where it's likely to buckle so the corners stick better. Also babysit your print, press down the corners once so often before it starts to bucklby dfrogy - Reprappers
I've been printing with blue transient and black and the black seems to not is stick is good as the blue but if I clean the bed and hairspray before heat up the bed it seems to stick pretty good if you have any other problems or if you have any more suggestions let me know thank youby dfrogy - Reprappers
update clean the bed spraying cold let it dry and heating is the best way i have found. but i am still new at 3D printing. i found if you keep bed on all the time it work good. thanks for helpby dfrogy - Reprappers
it is arduino's library thanks i am thinking i got a bad screenby dfrogy - Reprappers
hooked up smart controller to the Rams board downloaded u8glib put it in marlin library. and still don't work. and i define it in marlin. when it plug in the screen light up but row of lines in the mid of the screen if you have suggestion that would be greatby dfrogy - Reprappers
i changed to ponter face and works first try thanksby dfrogy - Reprappers
started my first print everything went to home and then once the print started it went to the opposite corner on the XY and started extruding filament out and then ended the print and went back to home any help would be great I have the folgers i3 prusaby dfrogy - Reprappers