i forgot to mention that when i re-enter G1 X0 yY0 Z0.4 the level of the hot end (Z) equals the strating level of the printing processby waelajam - Printing
Hi have a look please at this screenshot from Sli3rby waelajam - Printing
Hi I am using kossel mini delta 3D printer. Usually I print after auto-leveling it then I make sure that the Z coordinate is correct by sending G1 X0 Y0 Z0.4 (its location just 0.4mm above the heated bed). However when I send the print command the hot end goes down and stops at a level of nearly 10mm then it starts printing or let me say it tries to printby waelajam - Printing
Hi I could eventually diagnose the problem. It was the broken Z probe switch which is responsible for this disorder. There was a delay between the open status and the triggerred and sometimes it yields only triggerred.by waelajam - Reprappers
Hi everyone I am facing a problem with the auto-leveling of my kossel mini 3d printer. Right now I am trying to calibrate it by Pronterface but in vain Please has anyone a detailed instructions or preferably a video that explains the steps thouroughly and clearly. Please have a look at the problen in this video. It happened when sending G29 in Pronterface Thanksby waelajam - Reprappers