Hi, I have an inductive PNP-NO probe, which I connect to a 12V power source and through a voltage divider (12-->3,3V) to my BTT SKR 2.0 board. When I measure voltage on the signal pin it says 0 when there is no metal near the probe and 3,3V when there is. However, when I plug the signal wire into the z endstop in the board, the measured voltage without metal is 1,5V not 0. I believe this causeby Kyler - Reprappers
Hi, I am using a PNP - NO inductive probe (LJ12A3-4-Z/BY 4mm 6-36V) in my Hypercube build. Previously I had a BTT SKR 1.4, but had to switch to a BTT SKR MINI v1.1. The problem is it worked fine on the previous motherboard, but I had to enable pulldownresistor in Marlin. However, my current board doesn't have such option (compiler spits out an error) and the probe stays in one logic state regardlby Kyler - Reprappers
Hello, I have a serious issue with my printer, namely two days ago during printing I saw a flash of light and some smoke coming from the motherboard (btt skr 1.4). I immediately unplugged the cord and inspected the board, but couldn't see any obvious damage. It happened fast, but I am pretty sure that the problem (smoke, flash of light, spark) occured around the black coil with "150" written on iby Kyler - Reprappers
Ooh I see. So I just had to invert the Z axis so that + is downwards in Marlin FW and set Z endstop to min. Thank you very much for the help.by Kyler - Reprappers
Hi, so recently I set up a Hypercube 3D-printer based on Tech2C's project on thingiverse and everything is fine beside one thing. It's a core xy printer with moving bed, which is the problem - everywhere in Slic3r it say "moving nozzle" and I just can't find a topic explaining how to configure workspace in case of moving bed. Essentially it should start at max position and lower as the print goesby Kyler - Reprappers