If I issue a M502 and then a M500. Will it take the values from my marlin firmware and use them as my new eeprom settings? Trying to get my printer back to just using my marlin firmware that I uploaded using the Arduino app.by bblokey - Printing
Is this the same thing as Reset to Factory settings in Repetier using the gui window?by bblokey - Printing
I have a Folgertech Kossel 2020 printer and tried to fix an issue I was having with printing high after I switched my servo motor. I went through some steps as shown in this video Manual Delta Calibration using M665 and M666. I also used the following command M206 but I went wrong somewhere in the video. Now when I use the command M501 it shows my Z as 247.70 which is the height of my Z but notby bblokey - Printing
Wanted to get others opinion on an issue I have been having with my Folgertech Kossel 2020 and autolevel micro servo. When I send the M280 P0 S5 or S120 commands, the arm will not move and if I apply a bit of pressure on it then the servo moves. I already have an the servo on a 7805 voltage regulator since the boards could not supply enough power. So, I have a few questions: 1. Does it sound liby bblokey - Prusa i3 and variants