Hi Guys, i've just setup my Tevo Tornado with Marlin 2.0.x bugfix, UBL enabled. i did my mesh G29 P1 , then P3 until full, then saved, activated ETC. but when i do a G26 , the head move a bit then do smal circle on the same spot over and over, no XYZ movement just E, so i get a nice puddle of filament !!! any idea why? i do have a A20M under Marlin 2.0.x with ubl working perfectely, i did comby mindstorm88 - Firmware - Marlin
Quotephisik I used there online config tool and just selected Zonestar 5 ADC button keypad and analog pin 1 on "User interface page". did exactely that, but keypad does not work for me . If i simply change this line #define FEATURE_Z_PROBE 1 , to 0 , keypad comes back to life but autolevel is disable !!! I don't understand what's going on !!!by mindstorm88 - Prusa i3 and variants
Hi Guys , any of you been able to use autolevel with Repetier 0.92.9??? if i load the firmware without autolevel enable i'm ok, as soon as i enable it , the keypad does not work anymore !!!by mindstorm88 - Prusa i3 and variants