@Jetiman: Hast du das Problem mit einer anderen Marlin Version in den Griff bekommen?by godysseus - Software
Hallo, ich verwende Marlin 1.1.0-RC2 der Start G-code lautet: M104 S240 M140 S110 G00 Z10 G28 X G28 Y G29 MFG Georgby godysseus - Software
Hallo zusammen, Ich kämpfe jetzt seit einiger Zeit mit meinem Drucker aber er will einfach nicht korrekt auf das Druckbett drucken. Grundsätzlich basiert der Drucker auf einem Prusa I3 von Replikeo, habe jedoch das Arduino getauscht sowie anderen Extruder (Titan) und Hotend (E3D V6). Ausserdem habe ich ein kleines Gehäuse darum gebaut mit LCD. Betrieben wird es mit Octoprint auf einem PI2,es klby godysseus - Software
Hallo zusammen, Ich habe einen Prusa i3 von Replikeo und das Problem auf 110 Grad zu kommen brauche ich ziemlich genau 45 Minuten. Meine Idee wäre das Heizbett gegen folgendes zu tauschen: Das Ding müsste ich direkt mit Netzspannung und einem ssr betreiben können ohne Gleichstrom oder? Hat jemand einen guten Vorschlag für ein gutes geeignetes ssr? Danke. Lg Georgby godysseus - Druck- und Heizbetten
Everything seems to be OK (configuration.h attached), hardware I have now split again and connected everything new. I worked with LCD and without. I worked with the power supply and without (only the arduino was connected to usb, no external power) (does that make any difference?). The temperature sensor has about 100k ohms @ room temperature. But it still don´t work. Should I still buy a newby godysseus - Prusa i3 and variants
Does it matter in which direction the parts are soldered? (on the picture attached) I ask because the left and the right are the same, but the font of the middle is reversed.by godysseus - Prusa i3 and variants
Hello, I´m still working for a week to solve a problem but I can´t clear the issue. My problem is I´m always getting a MINTEMP Error. I have the Replikeo Prusa i3 kid (I bought it in december) with 1 extruder and Marlin 1.1.0-RC2. My temp settings are: #define TEMP_SENSOR_0 1 #define TEMP_SENSOR_1 0 #define TEMP_SENSOR_2 0 #define TEMP_SENSOR_3 0 #define TEMP_SENSOR_BED 1 #define TEMP_RESIDENCYby godysseus - Prusa i3 and variants