I looked in the g-code and all is ok. I have to set the Slic3r, because if i say G1 Z5 , it is going 5 mm down. My Z-sensor is at z = 119, but the chip thinks there is 0, so it tried to print it and only drop plastic 12 cm down. I need to start printing at 0 (real coordinate, for mc...microcontroller 119) and then go up(mc... go down). Which is the right setting, i tried a lot, but i did notby Ogris - Printing
yes, i have and he found his 0 point(start/homepoint), but then he start to print in the air.by Ogris - Printing
Hello, i am working with a RepRap Prusa-Mendel 3DP01 and Repetier Host. If i slice a programm and start it from a sd card the printer "drop" platic 11 cm obove the bed. He tried to print the Objekt from the other site (the lowest layer is the highest layer and the highest layer is the lowest layer and the objekt is flying in the air). Sorry for my bad english. I hope you can help me. Maxby Ogris - Printing
Thank you for help, i am using a memory card now. Maxby Ogris - Prusa i3 and variants
Thank you for the tipp with the sd card. Its Working, but he is printing 11 cm obove the plate. I will try to fix this tomorow. Thank you for Help Maxby Ogris - Printing
I have a RepRap Prusa-Mendel 3DP01 with a Melzi controllborad. At repetier Host i only get waiting for Commands.... Pronterface is only "connecting...." and here is its log: Traceback (most recent call last): File "pronterface.py", line 1566, in connect File "printcore.pyc", line 76, in connect File "serial\serialwin32.pyc", line 30, in __init__ File "serial\serialutil.pyc", line 260, in __init__by Ogris - Printing
I have a RepRap Prusa-Mendel 3DP01 with a Melzi controllborad. At repetier Host i only get waiting for Commands.... Pronterface is only "connecting...." and here is its log: Traceback (most recent call last): File "pronterface.py", line 1566, in connect File "printcore.pyc", line 76, in connect File "serial\serialwin32.pyc", line 30, in __init__ File "serial\serialutil.pyc", line 260, iby Ogris - Prusa i3 and variants
Hey, I can not connect with my RepRap Prusa-Mendel 3DP01, which is conntrolled by a Melzi Adentissimo Board. Pronterface Log: Traceback (most recent call last): File "pronterface.py", line 1566, in connect File "printcore.pyc", line 76, in connect File "serial\serialwin32.pyc", line 30, in __init__ File "serial\serialutil.pyc", line 260, in __init__ File "serial\serialwin32.pyc", lineby Ogris - Prusa i3 and variants