Quotetjnamtiw When checking the fuses measure DC voltage across them. If you read 12 volts, they are blown. If you read 0, they are OK. Both fuses measure 0 across them.by Colt4D5 - Prusa i3 and variants
Last night, I had something printing- it was about 20 minutes into a 40 minute print- and I wandered into the kitchen to make some food, when suddenly I realized my printer was being mischievously quiet... When I went to go check on my little darling, it was just sitting there. My computer was still pushing g-code to it, but the printer was not operating. Symptoms: All of the USB powered functby Colt4D5 - Prusa i3 and variants
QuoteIMBoring25 Check your cooling settings in Slic3r. Most profiles apply a minimum layer time so that more plastic doesn't get laid over plastic that's still molten and make a mess of things. That setting will typically drive your speeds on smaller layers. You are absolutely correct, thank you sir!by Colt4D5 - Slic3r
Quoteav8r1 QuoteColt4D5 Hey guys, I have a question I am hoping someone here has already experienced and solved: I am using mostly stock folgertech settings. I am trying to nail out some quality issues, and subsequently am printing out a bunch of 20MM cubes. In that process, I notice that no matter what I set the speed settings in Slic3r to, the print takes roughly the same time to print. Even whby Colt4D5 - Prusa i3 and variants
Hey guys, I have a question I am hoping someone here has already experienced and solved: I am using mostly stock folgertech settings. I am trying to nail out some quality issues, and subsequently am printing out a bunch of 20MM cubes. In that process, I notice that no matter what I set the speed settings in Slic3r to, the print takes roughly the same time to print. Even when I set everything to sby Colt4D5 - Prusa i3 and variants
Hey guys, I have a question I am hoping someone here has already experienced and solved: I am using a Prusa i3 printer, Slic3r, and Repatier. I am trying to nail out some quality issues, and subsequently am printing out a bunch of 20MM cubes. In that process, I notice that no matter what I set the speed settings in Slic3r to, the print takes roughly the same time to print. Even when I set eveby Colt4D5 - Slic3r